Ultimaker 2 3D Printer: Arched iPad Stand FAIL
I printed this object on my Ultimaker 2 3D printer with PLA. 3D printers are not all they are made up to be, as the object design has a huge effect on how the object is printed. The temperature was set to 217C and 71C for the bed on the Ultimaker 2 printer. The rear arch stand broke loose around 4 hours into the job and 12 hours later I found it. The small base did not allow for enough surface area of adhesion. Special thanks to leszczfiz
I printed this object on my Ultimaker 2 3D printer with PLA. 3D printers are not all they are made up to be, as the object design has a huge effect on how the object is printed. The temperature was set to 217C and 71C for the bed on the Ultimaker 2 printer. The rear arch stand broke loose around 4 hours into the job and 12 hours later I found it. The small base did not allow for enough surface area of adhesion. Special thanks to leszczfiz