How to Reset Amcrest 5MP Turret Camera [IP5M-T1277EW-AI]
Get the camera https://amzn.to/41p4OSl (Amazon Affiliate Link) To reset the Amcrest 5MP Turret Camera IP5M-T1277EW-AI, please follow the instructions below: Locate the reset button: The reset button is located under the cover that gives access to the Micro SD card slot. It is a small, recessed button that requires a small tool to press. Power off the camera: Ensure that the camera is powered off by disconnecting the power adapter or removing it from the power source. Prepare a small tool, such a screw driver that you can use to press the reset button. Press and hold the reset button: Take the tool and press and hold the reset button. While holding the reset button, proceed to the next step. Power on the camera: While still holding the reset button, connect the power adapter or plug it back into the power source. Keep holding the reset button for about 15 to 20 seconds. Release the reset button: After holding the reset button for the specified time, release it. The camera will then reboot and begin the reset process. Wait for the reset to complete: Allow the camera a few minutes to complete the reset process. Reconfigure the camera: Once the reset process is finished, the camera will be restored to its default factory settings. You will need to set it up again as if it were a new camera. This typically involves connecting it to your network, configuring any other desired settings. Note: Resetting the camera will erase all previous configurations, including network settings, user accounts, and customized settings. Make sure to have any necessary information or backups before performing the reset. If you encounter any difficulties during the reset process or need further assistance, refer to the user manual provided with the camera or contact Amcrest's customer support for guidance.
Get the camera https://amzn.to/41p4OSl (Amazon Affiliate Link) To reset the Amcrest 5MP Turret Camera IP5M-T1277EW-AI, please follow the instructions below: Locate the reset button: The reset button is located under the cover that gives access to the Micro SD card slot. It is a small, recessed button that requires a small tool to press. Power off the camera: Ensure that the camera is powered off by disconnecting the power adapter or removing it from the power source. Prepare a small tool, such a screw driver that you can use to press the reset button. Press and hold the reset button: Take the tool and press and hold the reset button. While holding the reset button, proceed to the next step. Power on the camera: While still holding the reset button, connect the power adapter or plug it back into the power source. Keep holding the reset button for about 15 to 20 seconds. Release the reset button: After holding the reset button for the specified time, release it. The camera will then reboot and begin the reset process. Wait for the reset to complete: Allow the camera a few minutes to complete the reset process. Reconfigure the camera: Once the reset process is finished, the camera will be restored to its default factory settings. You will need to set it up again as if it were a new camera. This typically involves connecting it to your network, configuring any other desired settings. Note: Resetting the camera will erase all previous configurations, including network settings, user accounts, and customized settings. Make sure to have any necessary information or backups before performing the reset. If you encounter any difficulties during the reset process or need further assistance, refer to the user manual provided with the camera or contact Amcrest's customer support for guidance.