Monoprice i3 / Wanhao i3 Mini : Best Practices
How to print using the Monoprice i3 3d printer, which is a rebranded Wanhao i3 mini duplicator. Steps: 1.) Download Wanhao software: http://www.wanhao3dprinter.com/Down/ShowArticle.asp?ArticleID=56 2.) Install and Run Cura 3.) Drag models into Cura and position on bed 4.) Level your bed on the i3. Make sure only a piece of paper can fit between the extruder and the bed at each corner. I usually put a piece of paper under it, tighten it until the paper cannot slide freely, then loosen unti it can. 5.) Print away! (100-140 % speed and upto 210 Degrees on the temp)
How to print using the Monoprice i3 3d printer, which is a rebranded Wanhao i3 mini duplicator. Steps: 1.) Download Wanhao software: http://www.wanhao3dprinter.com/Down/ShowArticle.asp?ArticleID=56 2.) Install and Run Cura 3.) Drag models into Cura and position on bed 4.) Level your bed on the i3. Make sure only a piece of paper can fit between the extruder and the bed at each corner. I usually put a piece of paper under it, tighten it until the paper cannot slide freely, then loosen unti it can. 5.) Print away! (100-140 % speed and upto 210 Degrees on the temp)